GMP J Lasher with Case

The Model J2 Cable Lasher is used to lash a single aerial cable or numerous cables to a supporting strand or to an existing lashed cable with stainless steel lashing wire. Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable lifters, cable and strand rollers. Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break. Constructed with heat-treated, plated steel, stainless steel, brass and aluminum components. Contains sealed and oiless bearings to minimize maintenance and assure durability. Pre-drilled and tapped at the factory for mounting of the lasher guard or “halo”. For use when lashing in overgrown areas. The J2 and every GMP lasher is fully serviceable to “good-as-new” specifications at our factory and at factory-trained service locations around the globe. Specifications: Will lash any single or multiple aerial cables up to 3” (76mm) diameter across on any suspension strand from 1/4” (6mm) to 7/16” (11mm). A factory modification will allow the lasher to accommodate 1/2” (12.7mm) strand if necessary. Each of two recessed magazines will hold a 1200’ coil of .045” (365m of 1.1mm wire) lashing wire (or 450’ of .065”). The Lashing Wire is fully recessed and covered by a gate.